[Previous entry: "Making the electrical connections!"] [Main Index] [Next entry: "Making the skin."]
04/24/2006: "Putting It All Together!"
Now we will put it all in the case, and yes IT WILL FIT!Now is the time to solder your USB wires to the card buss of the camera. Instructions on how to do this can be found at CameraHacking.com.
Be sure to insulate the USB port from the camera's circuit board. I split a piece of shrink wrap and stuck it on with spray on adhesive.
Next plug in the negative post to the circuit board.
Now carefully route the wires around the lens and screw the board down.
See it really does fit!
With the back of the case in place.
With the battery cover. (Yes the cam is on!)
Camera charging. (I still need to glue the plug over the buss card slot.)
Powered on and working great!
Our final step is to finish the cam by personalizing it. To do this we will make a new wrap around skin for the cam.
[Previous entry: "Making the electrical connections!"] [Main Index] [Next entry: "Making the skin."]
